Sand Production Monitoring

ClampOn’s Particle monitors provide means of monitoring, controlling and minimizing the production of sand to optimize oil and gas production and preserve system integrity. The utilization of a non-intrusive retrofit particle monitor, helps detect and quantify solids in oil / gas production streams, providing real-time readings to new stand-alone system or existing Master Control System.

It has the following specifications:

• Method of installation: Non-intrusive
• Minimum particle size: Oil/water: 25 microns/1PPM
• Air/gas: 15 microns/1 PPM
• Minimum sand rate: 0.01 g/s
• Minimum flow velocity: 0.5 m/s
• Repeatability: Better than 1%

Topside

• Uncertainty*: ±5% (with calibration by means of sand injections)
• Interface options: RS485 (ASCII, binary, ModBus RTU), 4-20mA for topside
• Pipe surface temperature: -40 ºC to 125 ºC [-40 ºF to 257 ºF ]**
• Flow regimes: Oil, gas, water, multiphase
• Ingress protection: IP66/IP68
• Housing material: Intelligent health-test of electronic hardware
• Ex approval: Ex ia, Ex d
• Power Consumption: Max 1.6 Watt per sensor

ClampOn Topside SandQ

Subsea

• Interface options: RS485, Modbus, Canbus, SIIS, 4-20mA
• Flow regimes:  Oil, gas, water, multiphase
• Max water depth:  3048 meters [10000 ft.]
• Design lifetime (MTBF): 220 000 hours (25 years)
• Hose/jumper interface: Bennex or ODI / jumper or bulkhead
• Power supply: 12-28VDC, 1.2W (single electronics)

ClampOn Subsea DSP Particle Monitor